Hi,
I was running a black/white job and noticed some striping so I did a clean, and of course it ate up the remaiing of my magenta and noted that I needed to replace. I did a re-start, and it continued to ask me to replace - but when I hit the "?", it does state I should be able to continue printing black only prints. It also states this in the manual.
I cannot get the "Add Ink" screen to leave, and desparetely need to finish this job. My print queue is empty, and I've tried reprinting in balck mode as I have been doing, but the job isn't going through and I can't get the printer screen to clear.
Is there anything I can do to enable the Run Black mode?
Thank you so much in advance!